Brownsville Area Roofing Contractor. Free Estimates

Replacing your roof isn't just about shingles. We install ice and water shield in the valleys and along eaves, synthetic underlayment across the whole deck, new drip edge on rake and eave, starter strip, and ridge vent. That's how a roof lasts 30 years in California.

After we fix your roof, we send you before-and-after photos and a written warranty. If it leaks again from the same spot within 5 years, we come back free. That's the deal.

Wind speeds over 60 mph cause shingle tab lift and seal failure. Hail over 1" diameter causes fractures through the shingle mat to the fiberglass reinforcement. Our HAAG-trained inspectors know the difference between cosmetic damage and functional damage. That distinction determines your insurance payout.

We price new installs by the roofing square (100 sq ft). Architectural shingles in Brownsville typically run $350-$550 per square installed, depending on the pitch and access. That includes materials, labor, cleanup, and warranty registration.

Corrugated metal and R-panel are cost-effective options for barns, detached shops, and covered patios in Brownsville. We install 29-gauge and 26-gauge corrugated with exposed fasteners using neoprene washer screws. For homes, we recommend 24-gauge standing seam with concealed fasteners. Cleaner look, no exposed fastener maintenance. DaVinci composite shake and slate profiles give you the metal longevity with a traditional California aesthetic.

Three-tab shingles are cheaper upfront but they don't hold up like architectural. We recommend them for sheds, detached garages, and rental properties where budget matters more than aesthetics. For your Brownsville home? Go architectural.

Commercial flat roof replacement in Brownsville starts with a core sample to check the existing insulation. If it's waterlogged, everything comes off. If it's dry, we can sometimes overlay. Saves you $2-$4 per square foot.

Flat roofs on commercial buildings are a different animal. We install and repair TPO, EPDM, modified bitumen, and built-up systems. Our Brownsville commercial crew handles retail, warehouse, office, and multi-family buildings.

Gutter replacement in Brownsville runs $8-$15 per linear foot installed, depending on material and story height. That includes hangers every 24 inches, end caps, miters, and outlet drops. We custom-form everything on-site.

Infrared moisture scanning available for Brownsville commercial and flat roof inspections. Thermal imaging locates trapped moisture in the insulation layer without cutting core samples. We use Flir E8 cameras to map wet areas, then core sample only the suspect zones to confirm. Saves time, reduces disruption, and gives you a precise repair scope instead of a guess.

We keep tarps, plywood, and common repair materials on every truck. When you call (877) 586-1316 for an emergency, our crew shows up ready to work. Not ready to give you a sales pitch.

We install, replace, and repair skylights in Brownsville homes. Fogged glass, cracked frames, persistent leaks around old skylights. We fix it all. Sometimes replacing a 20-year-old skylight is cheaper than trying to repair it.