Gowen, MI Roofing Contractor. Licensed & Insured

Our Gowen crews tear off and replace 15-20 roofs a month. That kind of volume means tight installs, clean job sites, and no wasted time. Most homes are done in a day. Two-story steep-pitch jobs take two.

Missing shingles, cracked flashing, a leak over the kitchen. Whatever it is, we fix it. Our Gowen repair crew runs 6 days a week. Most repairs take half a day.

Wind damage doesn't always look obvious from the ground. Lifted shingles, broken seals, exposed nail heads. You can't see any of that without getting on the roof. Our Gowen inspector does a full 27-point inspection, free of charge.

Building a new home in Gowen? Our crew works directly with your GC or we self-perform. We handle everything from the decking up: underlayment, ventilation design, material installation, and final inspection.

Corrugated metal and R-panel are cost-effective options for barns, detached shops, and covered patios in Gowen. We install 29-gauge and 26-gauge corrugated with exposed fasteners using neoprene washer screws. For homes, we recommend 24-gauge standing seam with concealed fasteners. Cleaner look, no exposed fastener maintenance. DaVinci composite shake and slate profiles give you the metal longevity with a traditional Michigan aesthetic.

Asphalt shingle roofing is the most common and cost-effective roofing system in Gowen. Our crews install 15-20 shingle roofs a month. We know the product inside and out. Nailing patterns, exposure measurements, hip and ridge details.

Modified bitumen is our go-to for residential flat roofs in Gowen. Two-ply torch-applied system with a granulated cap sheet. It handles foot traffic, thermal cycling, and Michigan UV better than single-ply at the residential scale.

We install Carlisle SynTec TPO and EPDM membrane systems with full Carlisle manufacturer warranties. Our Gowen commercial roofing crews are factory-trained and authorized. TPO seams are hot-air welded at 900+ degrees. The weld is stronger than the membrane itself. Ponding water? We install tapered ISO insulation to create positive drainage per NRCA guidelines.

Half-round copper gutters with round downspouts. That's the premium install. We solder joints on-site using 50/50 tin-lead solder. Copper develops a natural patina in Michigan's climate within 5-7 years. For aluminum, we use Spectra Metals .027 gauge seamless with Raytec hidden hangers rated to hold 25 lbs per linear foot of ice and debris load.

Our 27-point roof inspection covers: shingle condition, granule loss, nail pops, lifting tabs, ridge cap integrity, valley flashing, step flashing at walls, drip edge, pipe boot seals, vent function, soffit ventilation, gutter pitch, downspout capacity, fascia condition, decking (from attic if accessible), and visible signs of moisture in the attic. Written report with photos emailed same day.

After we tarp and secure your roof, we document everything for insurance purposes. Photos, measurements, damage descriptions. Your adjuster gets a professional report, not a handwritten note.

A skylight installed wrong will leak. The flashing has to integrate with the shingle courses. Step flashing on the sides, headwall flashing on top, and a sill pan underneath. We use manufacturer flashing kits because they're engineered to work with the skylight frame.