Idaho Springs Area Roofing Contractor. Licensed & Insured

Owens Corning Duration shingles with SureNail technology rated to ASTM D3462 and D7158 Class H wind resistance. Our Idaho Springs crews install TruDefinition Duration in a full Owens Corning system. ProArmor synthetic underlayment, VentSure ridge vent, and Starter+ starter strip. Preferred Protection warranty included.

Not every problem needs a full replacement. Sometimes it's a blown-off shingle, a cracked pipe boot, or deteriorated valley flashing. We diagnose the actual issue and fix that. We don't upsell you into a new roof you don't need.

Wind damage doesn't always look obvious from the ground. Lifted shingles, broken seals, exposed nail heads. You can't see any of that without getting on the roof. Our Idaho Springs inspector does a full 27-point inspection, free of charge.

Building a new home in Idaho Springs? Our crew works directly with your GC or we self-perform. We handle everything from the decking up: underlayment, ventilation design, material installation, and final inspection.

Corrugated metal and R-panel are cost-effective options for barns, detached shops, and covered patios in Idaho Springs. We install 29-gauge and 26-gauge corrugated with exposed fasteners using neoprene washer screws. For homes, we recommend 24-gauge standing seam with concealed fasteners. Cleaner look, no exposed fastener maintenance. DaVinci composite shake and slate profiles give you the metal longevity with a traditional Colorado aesthetic.

GAF Timberline HDZ architectural shingles with StrikeZone nailing area. The highest-selling shingle in North America. Impact-rated to UL 2218 Class 4 when installed with the full GAF Roof System. Our Idaho Springs crews install Timberline in the full system configuration to qualify for Golden Pledge warranty. ASTM D3462 and D7158 Class H certified.

TPO single-ply membrane in 60-mil or 80-mil thickness, hot-air welded seams, fully adhered or mechanically attached over polyiso insulation board. We install per NRCA and manufacturer specifications. Ponding water is the number one cause of flat roof failure. We use tapered ISO insulation to create minimum 1/4" per foot slope to drains. FM 4473 rated systems available for hail-prone Idaho Springs areas.

We install Carlisle SynTec TPO and EPDM membrane systems with full Carlisle manufacturer warranties. Our Idaho Springs commercial roofing crews are factory-trained and authorized. TPO seams are hot-air welded at 900+ degrees. The weld is stronger than the membrane itself. Ponding water? We install tapered ISO insulation to create positive drainage per NRCA guidelines.

Gutters aren't glamorous, but they're protecting your foundation, your fascia, and your landscaping. We install seamless aluminum gutters custom-formed on-site from a roll of coil stock. No seams means no leaks.

Our 27-point roof inspection covers: shingle condition, granule loss, nail pops, lifting tabs, ridge cap integrity, valley flashing, step flashing at walls, drip edge, pipe boot seals, vent function, soffit ventilation, gutter pitch, downspout capacity, fascia condition, decking (from attic if accessible), and visible signs of moisture in the attic. Written report with photos emailed same day.

Storm damage, fallen trees, sudden leaks. We handle all roofing emergencies in Idaho Springs. First we stop the water, then we fix the cause. Emergency response available 7 days a week.

VELUX FS fixed skylights and VS vented skylights installed with EDL flashing kits for profile roofing. The flashing integrates with your shingle courses per IRC R903.2 weather protection requirements. We cut the opening, frame the curb with doubled 2x lumber, install the skylight with factory sealant, and weave the flashing into the existing shingle field. Leak-proof when done right. And we do it right in Idaho Springs.