Trusted Okmulgee Roofing Experts | 16+ Years

Replacing your roof isn't just about shingles. We install ice and water shield in the valleys and along eaves, synthetic underlayment across the whole deck, new drip edge on rake and eave, starter strip, and ridge vent. That's how a roof lasts 30 years in Oklahoma.

Missing shingles cause water intrusion through the exposed underlayment and decking. We don't just replace the missing shingle. We check the deck for moisture damage with a Protimeter pin meter, replace any compromised underlayment, and weave new CertainTeed Landmark shingles into the existing pattern.

Wind damage doesn't always look obvious from the ground. Lifted shingles, broken seals, exposed nail heads. You can't see any of that without getting on the roof. Our Okmulgee inspector does a full 27-point inspection, free of charge.

New construction roof installation following IRC Section R905 and local Okmulgee building code amendments. We calculate ventilation per IRC R806 (1:150 ratio reduced to 1:300 when 50% is within 3ft of ridge. Synthetic underlayment per ASTM D226, ice barrier per ASTM D1970 at eaves in freeze-thaw climate zones. Manufacturer-certified installation locks in the full system warranty.

Corrugated metal and R-panel are cost-effective options for barns, detached shops, and covered patios in Okmulgee. We install 29-gauge and 26-gauge corrugated with exposed fasteners using neoprene washer screws. For homes, we recommend 24-gauge standing seam with concealed fasteners. Cleaner look, no exposed fastener maintenance. DaVinci composite shake and slate profiles give you the metal longevity with a traditional Oklahoma aesthetic.

Three-tab shingles are cheaper upfront but they don't hold up like architectural. We recommend them for sheds, detached garages, and rental properties where budget matters more than aesthetics. For your Okmulgee home? Go architectural.

TPO single-ply membrane in 60-mil or 80-mil thickness, hot-air welded seams, fully adhered or mechanically attached over polyiso insulation board. We install per NRCA and manufacturer specifications. Ponding water is the number one cause of flat roof failure. We use tapered ISO insulation to create minimum 1/4" per foot slope to drains. FM 4473 rated systems available for hail-prone Okmulgee areas.

Modified bitumen (mod-bit) is still the best choice for high-traffic commercial roofs in Okmulgee. We torch-apply SBS-modified base and cap sheets over properly primed concrete or approved decking. Two-ply mod-bit systems carry 20-year NDL (No Dollar Limit) warranties through GAF, Firestone, or Johns Manville. NRCA member. We follow the manual.

Improperly sized gutters cause fascia board rot and foundation erosion. We calculate gutter capacity using the rainfall intensity formula: roof square footage x pitch factor x rainfall rate (inches/hr for Okmulgee). Standard 5" K-style handles 5,520 sq ft of effective roof area. Bigger roofs or steeper pitches need 6" gutters with 3x4" downspouts. We hang with hidden hangers screwed into rafter tails every 24".

Roof inspections after a storm are free. Always. We document hail hits, wind damage, and any pre-existing issues so your insurance claim is accurate and complete.

Emergency tarping is the first priority. We cover the exposed area to stop water entry, then schedule the permanent repair once conditions allow. We don't charge extra for emergency tarp jobs. It's part of the repair cost.

VELUX FS fixed skylights and VS vented skylights installed with EDL flashing kits for profile roofing. The flashing integrates with your shingle courses per IRC R903.2 weather protection requirements. We cut the opening, frame the curb with doubled 2x lumber, install the skylight with factory sealant, and weave the flashing into the existing shingle field. Leak-proof when done right. And we do it right in Okmulgee.