Local Powder Springs Roofing Contractor | 20+ Years

Our Powder Springs crews tear off and replace 15-20 roofs a month. That kind of volume means tight installs, clean job sites, and no wasted time. Most homes are done in a day. Two-story steep-pitch jobs take two.

Missing shingles cause water intrusion through the exposed underlayment and decking. We don't just replace the missing shingle. We check the deck for moisture damage with a Protimeter pin meter, replace any compromised underlayment, and weave new CertainTeed Landmark shingles into the existing pattern.

Wind speeds over 60 mph cause shingle tab lift and seal failure. Hail over 1" diameter causes fractures through the shingle mat to the fiberglass reinforcement. Our HAAG-trained inspectors know the difference between cosmetic damage and functional damage. That distinction determines your insurance payout.

New construction roof installation following IRC Section R905 and local Powder Springs building code amendments. We calculate ventilation per IRC R806 (1:150 ratio reduced to 1:300 when 50% is within 3ft of ridge. Synthetic underlayment per ASTM D226, ice barrier per ASTM D1970 at eaves in freeze-thaw climate zones. Manufacturer-certified installation locks in the full system warranty.

Standing seam metal lasts 40-60 years with practically zero maintenance. Higher upfront cost than shingles, but you'll never replace it again. Our Powder Springs metal crews do residential and commercial.

Asphalt shingle roofing is the most common and cost-effective roofing system in Powder Springs. Our crews install 15-20 shingle roofs a month. We know the product inside and out. Nailing patterns, exposure measurements, hip and ridge details.

TPO single-ply membrane in 60-mil or 80-mil thickness, hot-air welded seams, fully adhered or mechanically attached over polyiso insulation board. We install per NRCA and manufacturer specifications. Ponding water is the number one cause of flat roof failure. We use tapered ISO insulation to create minimum 1/4" per foot slope to drains. FM 4473 rated systems available for hail-prone Powder Springs areas.

Our Powder Springs commercial crews handle everything from small retail strip centers to 50,000 sq ft warehouses. TPO, EPDM, modified bitumen, metal. We're certified installers for all major commercial membrane systems.

Gutter replacement in Powder Springs runs $8-$15 per linear foot installed, depending on material and story height. That includes hangers every 24 inches, end caps, miters, and outlet drops. We custom-form everything on-site.

We climb up, walk the entire roof, and document what we find with photos and measurements. Takes about 30 minutes. You see exactly what we see. No mysteries, no scare tactics.

We keep tarps, plywood, and common repair materials on every truck. When you call (877) 586-1316 for an emergency, our crew shows up ready to work. Not ready to give you a sales pitch.

VELUX FS fixed skylights and VS vented skylights installed with EDL flashing kits for profile roofing. The flashing integrates with your shingle courses per IRC R903.2 weather protection requirements. We cut the opening, frame the curb with doubled 2x lumber, install the skylight with factory sealant, and weave the flashing into the existing shingle field. Leak-proof when done right. And we do it right in Powder Springs.