Rio Vista, CA Roof Installation & Repair. Licensed & Insured

We don't do shortcuts on replacements. Tear off the old roof, check the decking for soft spots, install synthetic underlayment, drip edge, starter strip, shingles, ridge vent. The whole system. Your roof is only as good as the layers underneath.

After we fix your roof, we send you before-and-after photos and a written warranty. If it leaks again from the same spot within 5 years, we come back free. That's the deal.

Wind damage doesn't always look obvious from the ground. Lifted shingles, broken seals, exposed nail heads. You can't see any of that without getting on the roof. Our Rio Vista inspector does a full 27-point inspection, free of charge.

New construction roof installation following IRC Section R905 and local Rio Vista building code amendments. We calculate ventilation per IRC R806 (1:150 ratio reduced to 1:300 when 50% is within 3ft of ridge. Synthetic underlayment per ASTM D226, ice barrier per ASTM D1970 at eaves in freeze-thaw climate zones. Manufacturer-certified installation locks in the full system warranty.

Corrugated metal and R-panel are cost-effective options for barns, detached shops, and covered patios in Rio Vista. We install 29-gauge and 26-gauge corrugated with exposed fasteners using neoprene washer screws. For homes, we recommend 24-gauge standing seam with concealed fasteners. Cleaner look, no exposed fastener maintenance. DaVinci composite shake and slate profiles give you the metal longevity with a traditional California aesthetic.

GAF Timberline HDZ architectural shingles with StrikeZone nailing area. The highest-selling shingle in North America. Impact-rated to UL 2218 Class 4 when installed with the full GAF Roof System. Our Rio Vista crews install Timberline in the full system configuration to qualify for Golden Pledge warranty. ASTM D3462 and D7158 Class H certified.

TPO single-ply membrane in 60-mil or 80-mil thickness, hot-air welded seams, fully adhered or mechanically attached over polyiso insulation board. We install per NRCA and manufacturer specifications. Ponding water is the number one cause of flat roof failure. We use tapered ISO insulation to create minimum 1/4" per foot slope to drains. FM 4473 rated systems available for hail-prone Rio Vista areas.

We install Carlisle SynTec TPO and EPDM membrane systems with full Carlisle manufacturer warranties. Our Rio Vista commercial roofing crews are factory-trained and authorized. TPO seams are hot-air welded at 900+ degrees. The weld is stronger than the membrane itself. Ponding water? We install tapered ISO insulation to create positive drainage per NRCA guidelines.

Gutter replacement in Rio Vista runs $8-$15 per linear foot installed, depending on material and story height. That includes hangers every 24 inches, end caps, miters, and outlet drops. We custom-form everything on-site.

We climb up, walk the entire roof, and document what we find with photos and measurements. Takes about 30 minutes. You see exactly what we see. No mysteries, no scare tactics.

Storm damage, fallen trees, sudden leaks. We handle all roofing emergencies in Rio Vista. First we stop the water, then we fix the cause. Emergency response available 7 days a week.

VELUX FS fixed skylights and VS vented skylights installed with EDL flashing kits for profile roofing. The flashing integrates with your shingle courses per IRC R903.2 weather protection requirements. We cut the opening, frame the curb with doubled 2x lumber, install the skylight with factory sealant, and weave the flashing into the existing shingle field. Leak-proof when done right. And we do it right in Rio Vista.