Wendell Roofing Contractor. Free Estimates

Replacing your roof isn't just about shingles. We install ice and water shield in the valleys and along eaves, synthetic underlayment across the whole deck, new drip edge on rake and eave, starter strip, and ridge vent. That's how a roof lasts 30 years in Idaho.

Not every problem needs a full replacement. Sometimes it's a blown-off shingle, a cracked pipe boot, or deteriorated valley flashing. We diagnose the actual issue and fix that. We don't upsell you into a new roof you don't need.

HAAG Certified Inspector on every storm claim we handle in Wendell. HAAG certification is the insurance industry standard for forensic roof inspection. Adjusters trust our reports. We document hail hits per square, wind creasing, and granule displacement. FM 4473 hail resistance ratings determine whether your roof qualifies for full replacement or spot repair.

Building a new home in Wendell? Our crew works directly with your GC or we self-perform. We handle everything from the decking up: underlayment, ventilation design, material installation, and final inspection.

Standing seam metal lasts 40-60 years with practically zero maintenance. Higher upfront cost than shingles, but you'll never replace it again. Our Wendell metal crews do residential and commercial.

Architectural shingles are what 80% of Wendell homeowners choose. They look better than 3-tab, last longer, and handle wind better. We install GAF Timberline, Owens Corning Duration, and CertainTeed Landmark.

TPO single-ply membrane in 60-mil or 80-mil thickness, hot-air welded seams, fully adhered or mechanically attached over polyiso insulation board. We install per NRCA and manufacturer specifications. Ponding water is the number one cause of flat roof failure. We use tapered ISO insulation to create minimum 1/4" per foot slope to drains. FM 4473 rated systems available for hail-prone Wendell areas.

We install Carlisle SynTec TPO and EPDM membrane systems with full Carlisle manufacturer warranties. Our Wendell commercial roofing crews are factory-trained and authorized. TPO seams are hot-air welded at 900+ degrees. The weld is stronger than the membrane itself. Ponding water? We install tapered ISO insulation to create positive drainage per NRCA guidelines.

Half-round copper gutters with round downspouts. That's the premium install. We solder joints on-site using 50/50 tin-lead solder. Copper develops a natural patina in Idaho's climate within 5-7 years. For aluminum, we use Spectra Metals .027 gauge seamless with Raytec hidden hangers rated to hold 25 lbs per linear foot of ice and debris load.

Infrared moisture scanning available for Wendell commercial and flat roof inspections. Thermal imaging locates trapped moisture in the insulation layer without cutting core samples. We use Flir E8 cameras to map wet areas, then core sample only the suspect zones to confirm. Saves time, reduces disruption, and gives you a precise repair scope instead of a guess.

Emergency roof repairs for active water intrusion follow a strict protocol: tarping with reinforced polyethylene sheeting secured to the roof deck, interior water extraction guidance, and temporary flashing at penetrations. Our Wendell emergency crews carry 20x30 tarps, 2x4 nailer boards, and masonry anchors for various deck types. Permanent repairs are scheduled within 48-72 hours once materials are sourced.

A skylight installed wrong will leak. The flashing has to integrate with the shingle courses. Step flashing on the sides, headwall flashing on top, and a sill pan underneath. We use manufacturer flashing kits because they're engineered to work with the skylight frame.